Tile wall cladding

This type of decoration of the dwelling is very popular, but many are lost when they start work, not knowing how to start it correctly. Due to the small format of the article, in this note, we will miss some nuances associated with the pruning of ceramics and its drilling at the place of release out of communications. But instead, a very quick, simple and original way will be given here how to install the first two rows of facing material and apply glue to the wall.

How to high -quality wall tiles

1. Note that this method is suitable only in the case when a flat high -quality screed is flooded on the floor. If everything is done correctly and in level, then we will try to lay out a kind of lighthouse from the tiles. First, put the floor tile on the floor against the wall.


2. Next, put the wall tiles on top of it and put even pegs for the gap from below.


3. We will facing two rows at once, tiles. We put crosses on top of the first row and install the second row tile on them.


4. We apply a mark on the wall, indicating the height of the second row.


5. We do similar work on the opposite side of the wall.


6. We apply a line with a streaming cord along our marks.


7. We make calculations how much tiles will go to the row, and whether it will be necessary to cut it into pieces.


8. The wall is primed with a composition that has a deep penetration, and then a comb with teeth 6 mm wide, apply glue on it.


9. The walls of the walls in the corridor, toilet or bathroom with tiles are not particularly complicated, but it requires some skills. Application of glue is also the most important process that needs to be done thoroughly. First, put the comb at an angle to the wall, trying to withstand about 45 °.


10. We carry out the tool tightly along the wall and get an even layer of glue. We remove the excess solution from the comb to the bucket.


11. We do the same on the entire plane of the wall where the solution is applied. If you attach the tile and crush it to the wall, then under it you get a uniform layer of glue 2 mm thick.


12. Next, we do the same works as when marking. Put the floor tiles on the floor, install pegs on it and put the wall tiles of the first row on top.


13. We insert the crosses on top and fasten the tile of the second row. With us it goes exactly according to the marking line. We press the tile to the wall, slamming it to make the perfect plane.


14. In the same way we put the next tile, decorating the wall with two rows at once. The sex tile will need to be pulled out after a while when the glue dries a little, and then put it already overhaul it, driving in the place.


15. We pass by our two rows of material around the perimeter of the room and continue the cladding of walls with tiles in the bathroom. Further, the work will go much easier.